To find the settings of the BOM go into the document settings of the assembly or part and click on the BOM tab.
To get to the BOM itself:
The parts list is derived from the BOM, but is not the same thing. It seems to be closer to the metal. I think you can't do much with the BOM, whereas the parts list is more flexible.
Components can be
| 1. | Normal |
| 2. | Phantom, like screws nuts washers, ignored by the BOM but used in the mass calculations. |
| 3. | Referenced, these are not real components, but are present to help the drawing construction. Ignored by BOM and mass calculations. |
| 4. | Purchased, the component is a single BOM line |
| 5. | Inseperable, made of parts, but of parts which cannot be separated from each other |
See also substitution.