iLogic to change dimensions in sketches

Top  Previous  Next

It is a bit tricky but you can add a new rule and inside that rule set the named dimensions and parameters.


Inside a part add a rule. Here is an example, Blue words are parameters/dimensions from the part or sketch, so this block uses the two objects (DiamColl and DiamAtt) to change a diameter called Dcoll .


Dim RagColl as Double

Dim RagAtt As Double

RagColl = DiamColl/2.0

RagAtt = DiamAtt/2.0

If RagAtt < RagColl Then

   Dcoll = Sqrt((RagColl*RagColl) - (RagAtt*RagAtt))


   Dcoll = 0.0

End If



What is also a bit tricky is when things get triggered.


Text, images and diagrams © 2021 Owen F. Ransen. All rights reserved. (But copy the source code as much as you want!)